GROUND / JUMPER ASSEMBLY TESTER
• This tester is designed to test in-service grounding and jumpering cable assemblies
• Regular periodic use will ensure that jumper assemblies perform as designed for personnel safety
• Tester is completely self contained, portable and sets up in seconds. Any standard 120 volt grounded
outlet will provide power to the tester.
• A reference chart is provided for #2, 1/0, 2/0, and 4/0 Str. Cu. cables of specific lengths to determine
correct test values
• A built in digital meter allows the operator to easily input the correct voltage specified on the refer-
ence chart for various sizes and lengths of cable
• A built in digital ammeter tells the operator if the assembly is in good working condition
• Test electrodes are available to fit a variety of grounding equipment including elbows, grounding
bushings, and ball socket clamps
• Maximum voltage output is limited to protect the operator
• Pressure sensitive inspection labels are available to tag cables after testing
| CAT NO |
DESCRIPTION |
LBS |
| 7714 |
GROUND/JUMPER TESTER COMPLETE WITH
STANDARD ELECTRODE |
36.0 |
| P31347 |
STANDARD TEST ELECTRODE |
1.0 |
| A30367 |
GROUNDING ELBOW TEST ELECTRODE |
0.8 |
| A30368 |
GROUNDED PARKING STAND TEST
ELECTRODE |
0.5 |
| P31340 |
TEST ELECTRODE FOR 1 INCH BALL
SOCKET DESIGN GROUND CLAMP ASSEMBLY |
0.7 |
| A30387 |
TEST ELECTRODE FOR 20 mm BALL
SOCKET DESIGN GROUND CLAMP ASSEMBLY |
0.8 |
| A30366 |
TEST ELECTRODE FOR URD GROUND CLAMP
A10015 ASSEMBLY |
0.9 |
| P15099 |
PRESSURE SENSITIVE INSPECTION
LABELS - QTY 16 ON PEEL OFF CARD |
0.1 |
